ZyXEL Communications IES-22A - IGMP Count Set Command; IGMP Count Show Command; IGMP Snoop Statistics Commands

Chapter 48 IGMP Commands
IES-708-22A User’s Guide
307
48.6.3 IGMP Count Set Command
Syntax:
ras> switch igmpsnoop igmpcount set <portlist> <count>
where
This command sets the IGMP count limit for the specified DSL port(s).
The following command sets a IGMP count limit of 2 for port 4.
48.6.4 IGMP Count Show Command
Syntax:
ras> switch igmpsnoop igmpcount show [portlist]
where
This command displays the IGMP count limit setting status for the specified DSL port(s). The
following example displays the IGMP count limit settings for ports 1-5.
48.7 IGMP Snoop Statistics Commands
Use the IGMP Snoop Statistics commands to display current IGMP settings and statistics.
<portlist> =
You can specify a single DSL port <1>, all DSL ports <*> or a
list of DSL ports <1,3,5>. You can also include a range of ports
<1,5,6~8>.
<count> =
0..16; the maximum number of IGMP groups subscribers on the
specified port(s) can join.
ras> switch igmpsnoop igmpcount set 4 2
[portlist] =
You can specify a single DSL port <1>, all DSL ports <*> or a
list of DSL ports <1,3,5>. You can also include a range of ports
<1,5,6~8>.
ras> switch igmpsnoop igmpcount show 1~5
port enable count
---- ------ -----
1 - 5
2 - 5
3 - 5
4 - 5
5 - 5