ZyXEL Communications IES-22A - Transparent LAN Service (TLS) Commands; TLS PVC Delete Command; TLS PVC Set Command

Chapter 54 Virtual Channel Management
IES-708-22A User’s Guide
366
54.7 Transparent LAN Service (TLS) Commands
This feature is available in STU-C mode only.
" You can NOT configure PPPoA-to-PPPoE and TLS settings on the same PVC.
54.7.1 TLS PVC Delete Command
Syntax:
ras> shdsl tlspvc delete <portlist> <vpi> <vci>
where
This command clears TLS settings for the PVC.
54.7.2 TLS PVC Set Command
Syntax:
ras> shdsl tlspvc set <portlist> <vpi> <vci> <DS vcprofile[,US vcprofile]>
<pvid> <priority>
where
pppoe ac system
error
=
The number of times the access concentrator experienced an
error while performing the Host request; for example, when
resources are exhausted in the access concentrator. This value
does not include the number of times the IES-708-22A checks
the AC name field in the BRAS's reply PDU and finds a
mismatch, however.
pppoe generic
error
=
The number of other types of errors that occur in the PPPoE
session between the IES-708-22A and the BRAS.
<portlist> =
The port number of the TLS PVC. You can specify a single DSL
port <1>, all DSL ports <*> or a list of DSL ports <1,3,5>. You
can also include a range of ports <1,5,6~8>.
<vpi> =
The VPI of the TLS PVC.
<vci> =
The VCI of the TLS PVC.
<portlist> =
The port number of the TLS PVC. You can specify a single DSL
port <1>, all DSL ports <*> or a list of DSL ports <1,3,5>. You
can also include a range of ports <1,5,6~8>.
<vpi> =
The VPI of the TLS PVC.
<vci> =
The VCI of the TLS PVC.