Chapter 20 VLAN
NWA-3160 Series User’s Guide
237
Note: Use the out-of-band management port or console port to configure the switch if
you misconfigure the management VLAN and lock yourself out from performing
in-band management.
On an Ethernet switch, create a VLAN that has the same management VLAN
ID as the NWA. The following figure has the NWA connected to port 2 and your
computer connected to port 1. The management VLAN ID is 10.
Figure 141 Management VLAN Configuration Example
Perform the following steps in the switch web configurator:
1 Click VLAN under Advanced Application.
2 Click Static VLAN.
3 Select the ACTIVE check box.
4 Type a Name for the VLAN ID.
5 Type a VLAN Group ID. This should be the same as the management VLAN ID on
the NWA.
6 Enable Transmitted Packets (Tx) Tagging on the port which you want to
connect to the NWA. Disable Tx Tagging on the port you are using to connect to
your computer.
To Next Page
Loading...
