Chapter 20 VLAN
NWA-3160 Series User’s Guide
238
7 Under Control, select Fixed to set the port as a member of the VLAN.
Figure 142 VLAN-Aware Switch - Static VLAN
8 Click Apply. The following screen displays.
Figure 143 VLAN-Aware Switch
9 Click VLAN Status to display the following screen.
Figure 144 VLAN-Aware Switch - VLAN Status
Follow the instructions in the Quick Start Guide to set up your NWA for
configuration. The NWA should be connected to the VLAN-aware switch. In the
above example, the switch is using port 1 to connect to your computer and port 2
to connect to the NWA: Figure 141 on page 237.
1 In the NWA web configurator click VLAN to open the VLAN setup screen.
2 Select the Enable VLAN Tagging check box and type a Management VLAN ID
(10 in this example) in the field provided.
To Next Page
Loading...
