Appendix F How to Access and Use the CLI
NWA-3160 Series User’s Guide
340
2 Open a Telnet session to the NWA’s IP address. If this is your first login, use the
default values.
Make sure your computer IP address is in the same subnet, unless you are
accessing the NWA through one or more routers. In the latter case, make sure
remote management of the NWA is allowed via Telnet.
SSH
You can use this method if your NWA supports SSH connections.
1 Connect your computer to one of the Ethernet ports.
Use a SSH client program to access the NWA. If this is your first login, use the
default values in Table 109 on page 340 and Table 110 on page 340. Make sure
your computer IP address is in the same subnet, unless you are accessing the
NWA through one or more routers.
Logging in
Use the administrator username and password. If this is your first login, use the
default values. in some NWA models you may not need to enter the user name.
The NWA automatically logs you out of the management interface after five
minutes of inactivity. If this happens, simply log back in again. Use the sys stdio
set command to extend the idle timeout. For example, the NWA automatically
logs you out of the management interface after 60 minutes of inactivity after you
use the sys stdio set 60 command. Use the sys stdio show command to
display the current idle timeout setting.
Command Conventions
Command descriptions follow these conventions:
Table 109 Default Management IP Address
SETTING
DEFAULT
VALUE
IP Address 192.168.1.1
Subnet Mask 255.255.255.0
Table 110 Default User Name and Password
SETTING
DEFAULT
VALUE
User Name admin
Password 1234
To Next Page
Loading...
