ZyXEL Communications nwa series - File Manager Commands Input Values; File Manager Commands Summary

Chapter 18 File Manager
NWA/WAC Series CLI Reference Guide
100
18.3 File Manager Commands Input Values
The following table explains the values you can input with the file manager commands.
18.4 File Manager Commands Summary
The following table lists the commands that you can use for file management.
Table 62 File Manager Command Input Values
LABEL DESCRIPTION
file_name The name of a file. Use up to 25 characters (including a-zA-Z0-
9;‘~!@#$%^&()_+[]{}’,.=-).
Table 63 File Manager Commands Summary
COMMAND DESCRIPTION
apply /conf/file_name.conf [ignore-error]
[rollback]
Has the NWA/WAC use a specific configuration file. You must
still use the
write command to save your configuration
changes to the flash (“non-volatile” or “long term”) memory.
Use this command without specify both ignore-error and
rollback: this is not recommended because it would leave the
rest of the configuration blank. If the interfaces were not
configured before the first error, the console port may be the
only way to access the device.
Use ignore-error without rollback: this applies the valid
parts of the configuration file and generates error logs for all of
the configuration file’s errors. This lets the NWA/WAC apply
most of your configuration and you can refer to the logs for
what to fix.
Use both ignore-error and rollback: this applies the valid
parts of the configuration file, generates error logs for all of the
configuration file’s errors, and starts the NWA/WAC with a fully
valid configuration file.
Use rollback without ignore-error: this gets the NWA/WAC
started with a fully valid configuration file as quickly as
possible.
You can use the “apply /conf/system-default.conf”
command to reset the NWA/WAC to go back to its system
defaults.
copy {/cert | /conf | /idp | /packet_trace | /
script | /tmp}file_name-a.conf {/cert | /conf | /
idp | /packet_trace | /script | /tmp}/file_name-
b.conf
Saves a duplicate of a file on the NWA/WAC from the source
file name to the target file name.
Specify the directory and file name of the file that you want to
copy and the directory and file name to use for the duplicate.
Always copy the file into the same directory.
copy running-config startup-config Saves your configuration changes to the flash (“non-volatile”
or “long term”) memory. The NWA/WAC immediately uses
configuration changes made via commands, but if you do not
use this command or the write command, the changes will be
lost when the NWA/WAC restarts.
copy running-config /conf/file_name.conf Saves a duplicate of the configuration file that the NWA/WAC is
currently using. You specify the file name to which to copy.