ZyXEL Communications nwa series - Wireless Frame Capture Examples

Chapter 10 Wireless Frame Capture
NWA/WAC Series CLI Reference Guide
69
The following table describes the commands available for wireless frame capture. You must use the
configure terminal command to enter the configuration mode before you can use these
commands.
10.2.1 Wireless Frame Capture Examples
This example configures the wireless frame capture parameters for an AP located at IP address
192.168.1.2.
This example shows frame capture status and configuration.
Table 38 Command Summary: Wireless Frame Capture
COMMAND DESCRIPTION
frame-capture configure Enters sub-command mode for wireless frame capture.
src-ip add ip_address Sets the IP address of an AP controlled by the NWA/WAC that you
want to monitor. You can use this command multiple times to add
additional IPs to the monitor list.
file-prefix file_name Sets the file name prefix for each captured file. Enter up to 31
alphanumeric characters. Spaces and underscores are not
allowed.
files-size mon_file_size Sets the size (in kbytes) of files to be captured.
exit Exits configuration mode for wireless frame capture.
[no] frame-capture activate Starts wireless frame capture. Use the no parameter to turn it off.
show frame-capture status Displays whether frame capture is running or not.
show frame-capture config Displays the frame capture configuration.
Router(config)# frame-capture configure
Router(frame-capture)# src-ip add 192.168.1.2
Router(frame-capture)# file-prefix monitor
Router(frame-capture)# files-size 1000
Router(frame-capture)# exit
Router(config)#
Router(config)# show frame-capture status
capture status: off
Router(config)# show frame-capture config
capture source: 192.168.1.2
file prefix: monitor
file size: 1000