ZyXEL Communications nwa series - Security Profile Commands

Chapter 8 Wireless LAN Profiles
NWA/WAC Series CLI Reference Guide
58
8.4 Security Profile Commands
The following table identifies the values required for many of these commands. Other input values
are discussed with the corresponding commands.
The following table describes the commands available for security profile managment. You must use
the
configure terminal command to enter the configuration mode before you can use these
commands.
Table 25 Input Values for General Security Profile Commands
LABEL DESCRIPTION
security_profile_name The security profile name. You may use 1-31 alphanumeric characters,
underscores (
_), or dashes (-), but the first character cannot be a number. This
value is case-sensitive.
wep_key Sets the WEP key encryption strength. Select either 64bit or 128bit.
wpa_key Sets the WPA/WPA2 pre-shared key in ASCII. You may use 8~63 alphanumeric
characters. This value is case-sensitive.
wpa_key_64 Sets the WPA/WPA2 pre-shared key in HEX. You muse use 64 alphanumeric
characters.
secret Sets the shared secret used by your network’s RADIUS server.
auth-method The authentication method used by the security profile.
Table 26 Command Summary: Security Profile
COMMAND DESCRIPTION
show wlan-security-profile {all | rule_count |
[security_profile_name]}
Displays the security profile(s).
all: Displays all profiles.
rule_count: Displays how many security profiles are created on
the NWA/WAC.
security_profile_name: Displays the specified profile.
wlan-security-profile rename
security_profile_name1 security_profile_name2
Gives existing security profile (security_profile_name1) a new
name, (security_profile_name2).
[no] wlan-security-profile
security_profile_name
Enters configuration mode for the specified security profile. Use
the no parameter to remove the specified profile.
description description Sets the description for the profile. You may use up to 60
alphanumeric characters, underscores (_), or dashes (-). This
value is case-sensitive
mode <none | wep | wpa2 | wpa2-mix> Sets the security mode for this profile.
idle <30..30000> Sets the idle interval (in seconds) that a client can be idle before
authentication is discontinued.
The default is 3000.