ZyXEL Communications nwa series - Telnet; Telnet Commands; Telnet Commands Examples; Configuring FTP

Chapter 15 System Remote Management
NWA/WAC Series CLI Reference Guide
84
15.4 Telnet
You can configure your NWA/WAC for remote Telnet access.
15.5 Telnet Commands
The following table describes the commands available for Telnet. You must use the configure
terminal
command to enter the configuration mode before you can use these commands.
15.5.1 Telnet Commands Examples
This command displays Telnet settings.
15.6 Configuring FTP
You can upload and download the NWA/WAC’s firmware and configuration files using FTP. To use
this feature, your computer must have an FTP client.
Table 50 Command Summary: Telnet
COMMAND DESCRIPTION
[no] ip telnet server Allows Telnet access to the NWA/WAC CLI. The no
command disables Telnet access to the NWA/WAC CLI.
[no] ip telnet server port <1..65535> Sets the Telnet service port number. The
no command
resets the Telnet service port number back to the factory
default (23).
show ip telnet server status Displays Telnet settings.
Router# configure terminal
Router(config)# show ip telnet server status
active : yes
port : 23
service control:
No. Zone Address Action
========================================================================
Router(config)#