ZyXEL Communications nwa series - Port Command Examples

Chapter 5 Interfaces
NWA/WAC Series CLI Reference Guide
37
Note: In CLI, representative interfaces are also called representative ports.
5.3.1 Port Command Examples
The following example shows port status.
The following example shows port settings.
Table 10 Basic Interface Setting Commands
COMMAND DESCRIPTION
no port <1..x> Removes the specified physical port from its current
representative interface and adds it to its default
representative interface (for example, port x --> gex).
port status Port<1..x> Enters a sub-command mode to configure the specified
port’s settings.
[no] duplex <full | half> Sets the port’s duplex mode. The no command returns the
default setting.
exit Leaves the sub-command mode.
[no] negotiation auto Sets the port to use auto-negotiation to determine the port
speed and duplex. The no command turns off auto-
negotiation.
[no] speed <100,10> Sets the Ethernet port’s connection speed in Mbps. The no
command returns the default setting.
show port setting Displays the Ethernet port negotiation, duplex, and speed
settings.
show port status Displays statistics for the Ethernet ports.
show port type Displays the type of cable connection for each physical
interface on the device.
show manager vlan Displays the LAN interface’s management interface
settings.
Router# show port status
Port Status TxPkts RxPkts Colli. TxB/s RxB/s Up Time
===============================================================================
1 1000M/Full 1049 2438 0 0 0 16:53:51
Router(config)# show port setting
Port Negotiation Duplex Speed EEE
===============================================================================
1 auto full 1000 no