ZyXEL Communications nwa series - Session Timeout; Chapter 21 Session Timeout; Session Timeout Commands; Session Timeout Commands Example

NWA/WAC Series CLI Reference Guide 121
CHAPTER 21
Session Timeout
21.1 Session Timeout Commands
Use these commands to modify and display the session timeout values. You must use the
configure terminal command before you can use these commands.
21.1.1 Session Timeout Commands Example
The following example sets the UDP session connect timeout to 10 seconds, the UDP deliver session
timeout to 15 seconds, and the ICMP timeout to 15 seconds.
Table 75 Session Timeout Commands
COMMAND DESCRIPTION
session timeout {udp-connect <1..300> | udp-deliver
<1..300> | icmp <1..300>}
Sets the timeout for UDP sessions to connect or deliver and
for ICMP sessions.
session timeout { tcp-close <1..300> | tcp-closewait
<1..300> | tcp-established <1..432000> | tcp-finwait
<1..300> | tcp-lastack <1..300> | tcp-synrecv
<1..300> | tcp-synsent <1..300> | tcp-timewait
<1..300> | udp-connect <1..300> | ucp-deliver
<1..300> | icmp <1..300> }
Sets the timeout for TCP sessions in the ESTABLISHED,
SYN_RECV, FIN_WAIT, SYN_SENT, CLOSE_WAIT,
LAST_ACK, or TIME_WAIT state.
show session timeout {icmp | tcp-timewait | udp} Displays ICMP, TCP, and UDP session timeouts.
Router(config)# session timeout udp-connect 10
Router(config)# session timeout udp-deliver 15
Router(config)# session timeout icmp 15
Router(config)# show session timeout udp
UDP session connect timeout: 10 seconds
UDP session deliver timeout: 15 seconds
Router(config)# show session timeout icmp
ICMP session timeout: 15 seconds