ZyXEL Communications nwa series - System Resources

NWA/WAC Series CLI Reference Guide 77
CHAPTER 14
System
This chapter provides information on the commands that correspond to what you can configure in
the system screens.
14.1 System Overview
Use these commands to configure general NWA/WAC information, the system time and the console
port connection speed for a terminal emulation program. They also allow you to configure DNS
settings and determine which services/protocols can access which NWA/WAC zones (if any) from
which computers.
14.2 Host Name Commands
The following table describes the commands available for the hostname and domain name. You
must use the
configure terminal command to enter the configuration mode before you can use
these commands.
14.3 Time and Date
For effective scheduling and logging, the NWA/WAC system time must be accurate. There is also a
software mechanism to set the time manually or get the current time and date from an external
server.
Table 43 Command Summary: Host Name
COMMAND DESCRIPTION
[no] domainname <domain_name> Sets the domain name. The no command removes the
domain name.
domain_name: This name can be up to 254 alphanumeric
characters long. Spaces are not allowed, but dashes “-” and
underscores “_” are accepted.
[no] hostname <hostname> Sets a descriptive name to identify your NWA/WAC. The
no
command removes the host name.
show fqdn Displays the fully qualified domain name.