Chapter 15 System Remote Management
NWA/WAC Series CLI Reference Guide
85
15.6.1 FTP Commands
The following table describes the commands available for FTP. You must use the configure
terminal
command to enter the configuration mode before you can use these commands.
15.6.2 FTP Commands Examples
This command displays FTP settings.
15.7 SNMP
Simple Network Management Protocol is a protocol used for exchanging management information
between network devices. Your NWA/WAC supports SNMP agent functionality, which allows a
manager station to manage and monitor the NWA/WAC through the network. The NWA/WAC
supports SNMP version one (v1) and version three (v3).
15.7.1 Supported MIBs
The NWA/WAC supports MIB II that is defined in RFC-1213 and RFC-1215. The NWA/WAC also
supports private MIBs (ZYXEL-ES-SMI.MIB, ZYXEL-ES-CAPWAP.MIB, ZYXEL-ES-COMMON.MIB,
ZYXEL-ES-HybridAP.MIB, ZYXEL-ES-ProWLAN.MIB, ZYXEL-ES-RFMGMT.MIB and ZYXEL-ES-
WIRELESS.MIB) to collect information about CPU and memory usage. The focus of the MIBs is to let
administrators collect statistical data and monitor status and performance. You can download the
NWA/WAC’s MIBs from www.zyxel.com.
Table 51 Command Summary: FTP
COMMAND DESCRIPTION
[no] ip ftp server Allows FTP access to the NWA/WAC. The no command
disables FTP access to the NWA/WAC.
[no] ip ftp server cert certificate_name Sets a certificate to be used to identify the NWA/WAC.
The
no command resets the certificate used by the FTP
server to the factory default.
[no] ip ftp server port <1..65535> Sets the FTP service port number. The
no command
resets the FTP service port number to the factory default
(21).
[no] ip ftp server tls-required Allows FTP access over TLS. The
no command disables
FTP access over TLS.
show ip ftp server status Displays FTP settings.
Router# configure terminal
Router(config)# show ip ftp server status
active : yes
port : 21
certificate: default
TLS : no
service control:
No. Zone Address Action
========================================================================