ZyXEL Communications nwa series - LED Locator; LED Locator Commands; LED Locator Commands Example

Chapter 22 LEDs
NWA/WAC Series CLI Reference Guide
123
22.3 LED Locator
The LED locator feature identifies the location of your WAC among several devices in the network.
You can run this feature and set a timer.
22.4 LED Locator Commands
Use these commands to run the LED locator feature. You must use the configure terminal
command before you can use these commands.
22.4.1 LED Locator Commands Example
The following example turns on the LED locator feature and displays the settings.
Table 77 LED Locator Commands
COMMAND DESCRIPTION
led_locator on Enables the LED locator function. It will show the actual location
of the WAC between several devices in the network.
led_locator off Disables the LED locator function.
led_locator blink-timer <1..60> Sets a time interval between 1 and 60 minutes to stop the
locator LED from blinking.
show led_locator status Displays whether LED locator function is enabled and the timer
setting.
Router(config)# led_locator on
Router(config)# show led_locator status
Locator LED Status : ON
Locator LED Time : 10