ZyXEL Communications nwa series - WDS Profile Commands; WDS Profile Example

Chapter 8 Wireless LAN Profiles
NWA/WAC Series CLI Reference Guide
63
8.7 WDS Profile Commands
The following table identifies the values required for many of these commands. Other input values
are discussed with the corresponding commands.
The following table describes the commands available for WDS profile managment. You must use
the
configure terminal command to enter the configuration mode before you can use these
commands.
8.7.1 WDS Profile Example
The following example creates a WDS profile with the name ‘WDS1’, and shows the profile settings.
Table 31 Input Values for General WDS Profile Commands
LABEL DESCRIPTION
wds_profile_name The WDS profile name. You may use 1-31 alphanumeric characters,
underscores (
_), or dashes (-), but the first character cannot be a number. This
value is case-sensitive.
Table 32 Command Summary: WDS Profile
COMMAND DESCRIPTION
show wlan-wds-profile {all | rule_count |
[wds_profile_name]}
Displays the WDS profile(s) settings.
all: Displays settings of all WDS profiles configured on the NWA/
WAC.
rule_count: Displays how many WDS profiles are created on the
NWA/WAC.
wds_profile_name: Displays settings of the specified profile.
wlan-wds-profile rename wds_profile_name1
wds_profile_name2
Gives the existing WDS profile (wds_profile_name1) a new
name, (wds_profile_name2).
[no] wlan-wds-profile wds_profile_name Enters configuration mode for the specified WDS profile.
psk psk Sets a pre-shared key of between 8 and 63 case-sensitive ASCII
characters (including spaces and symbols) or 64 hexadecimal
characters.The key is used to encrypt the traffic between the APs.
ssid ssid Sets the SSID with which you want the NWA/WAC to connect to a
root AP or repeater to form a WDS.
exit Exits configuration mode for this profile.
Router(config)# wlan-wds-profile WDS1
Router(config-wlan-wds WDS1)# ssid ZyXEL-WDS
Router(config-wlan-wds WDS1)# psk qwer1234
Router(config-wlan-wds WDS1)# exit
Router(config)# show wlan-wds-profile WDS1
wds profile: WDS1
reference: 0
Id: 2
Description:
WDS_SSID: ZyXEL-WDS
WDS_PSK: qwer1234
Router(config)#