NWA/WAC Series CLI Reference Guide 122
CHAPTER 22
LEDs
This chapter describes two features that controls the LEDs of your NWA/WAC - Locator and
Suppression.
22.1 LED Suppression Mode
The LED Suppression feature allows you to control how the LEDs of your NWA/WAC behave after it’s
ready. The deafult LED suppression setting of your AP is different depending on your NWA/WAC
model.
Note: When the NWA/WAC is booting or performing firmware upgrade, the LEDs will lit
regardless of the setting in LED suppression.
22.2 LED Suppression Commands
Use these commands to set how you want the LEDs to behave after the device is ready. You must
use the configure terminal command before you can use these commands.
22.2.1 LED Suppression Commands Example
The following example activates LED suppression mode and displays the settings..
Table 76 LED Suppression Commands
COMMAND DESCRIPTION
led_suppress enable Sets the LEDs of your NWA/WAC to turn off after it’s ready.
led_suppress disable Sets the LEDs to stay lit after the NWA/WAC is ready.
show led_suppress status Displays whether LED suppression mode is enabled or
disabled on the NWA/WAC.
Router(config)# led_suppress enable
Router(config)# show led_suppress status
suppress mode status : Enable
To Next Page
Loading...
