ZyXEL Communications nwa series - Log Entries Commands; System Log Commands

Chapter 19 Logs
NWA/WAC Series CLI Reference Guide
111
19.1.1 Log Entries Commands
This table lists the commands to look at log entries.
19.1.2 System Log Commands
This table lists the commands for the system log settings.
Table 65 logging Commands: Log Entries
COMMAND DESCRIPTION
show logging entries [priority pri] [category
module_name] [srcip ip] [dstip ip] [service
service_name] [begin <1..1024> end <1..1024>]
[keyword keyword]
Displays the selected entries in the system log.
PRI: alert | crit | debug | emerg | error | info | notice |
warn
keyword: You can use alphanumeric and
()+/
:=?!*#@$_%- characters, and it can be up to 63
characters long.This searches the message, source,
destination, and notes fields.
show logging entries field field [begin <1..1024>
end <1..1024>]
Displays the selected fields in the system log.
field: time | msg | src | dst | note | pri | cat | all
Table 66 logging Commands: System Log Settings
COMMAND DESCRIPTION
show logging status system-log Displays the current settings for the system log.
logging system-log category module_name {disable |
level normal | level all}
Specifies what kind of information, if any, is logged in the
system log and debugging log for the specified category.
[no] logging system-log suppression interval
<10..600>
Sets the log consolidation interval for the system log. The
no command sets the interval to ten.
[no] logging system-log suppression Enables log consolidation in the system log. The no
command disables log consolidation in the system log.
[no] connectivity-check continuous-log activate Has the NWA/WAC generate a log for each connectivity
check. The no command has the NWA/WAC only log the
first connectivity check.
show connectivity-check continuous-log status Displays whether or not the NWA/WAC generates a log for
each connectivity check.
clear logging system-log buffer Clears the system log.