ZyXEL Communications nwa series - Chapter 10: Wireless; 10.1 Overview

Chapter 20 Reports and Reboot
NWA/WAC Series CLI Reference Guide
117
20.1.2 Report Command Examples
The following commands start collecting data, display the traffic reports, and stop collecting data.
20.2 Email Daily Report Commands
The following table identifies the values used in some of these commands. Other input values are
discussed with the corresponding commands.
Use these commands to have the NWA/WAC e-mail you system statistics every day. You must use
the
configure terminal command to enter the configuration mode before you can use these
commands.
Router# configure terminal
Router(config)# show report lan ip
No. IP Address User Amount Direction
===================================================================
1 192.168.1.4 admin 1273(bytes) Outgoing
2 192.168.1.4 admin 711(bytes) Incoming
Router(config)# show report lan service
No. Port Service Amount Direction
====================================================================
1 21 ftp 1273(bytes) Outgoing
2 21 ftp 711(bytes) Incoming
Router(config)# show report lan url
No. Hit URL
=====================================================================
1 1 140.114.79.60
Router(config)# show report status
Report status: on
Collection period: 0 days 0 hours 0 minutes 18 seconds
Table 73 Input Values for Email Daily Report Commands
LABEL DESCRIPTION
e_mail An e-mail address. You can use up to 80 alphanumeric characters, underscores (_),
periods (.), or dashes (-), and you must use the @ character.
Table 74 Email Daily Report Commands
COMMAND DESCRIPTION
show daily-report status Displays the e-mail daily report settings.
daily-report Enter the daily report sub-command mode.
[no] activate Turns daily e-mail reports on or off.
smtp-address {ip | hostname} Sets the SMTP mail server IP address or domain
name.
[no] smtp-auth activate Enables or disables SMTP authentication.
smtp-auth username username password password Sets the username and password for SMTP
authentication.
no smtp-address Resets the SMTP mail server configuration.
no smtp-auth username Resets the authentication configuration.