Chapter 20 Reports and Reboot
NWA/WAC Series CLI Reference Guide
118
mail-subject set subject Configures the subject of the report e-mails.
no mail-subject set Clears the configured subject for the report e-
mails.
[no] mail-subject append system-name Determines whether the system name will be
appended to the subject of report mail.
[no] mail-subject append date-time Determine whether the sending date-time will be
appended at subject of the report e-mails.
mail-from e_mail Sets the sender value of the report e-mails.
mail-to-1 e_mail Sets to whom the NWA/WAC sends the report e-
mails (up to five recipients).
mail-to-2 e_mail See above.
mail-to-3 e_mail See above.
mail-to-4 e_mail See above.
mail-to-5 e_mail See above.
[no] item ap-sta This command is supported when the NWA/WAC
is in standalone mode. Determines whether or
not the AP station statistics will be included in the
report e-mails.
[no] item ap-traffic This command is supported when the NWA/WAC
is in standalone mode. Determines whether or
not the AP traffic statistics will be included in the
report e-mails.
[no] item cpu-usage Determines whether or not CPU usage statistics
are included in the report e-mails.
[no] item mem-usage Determines whether or not memory usage
statistics are included in the report e-mails.
[no] item port-usage Determines whether or not port usage statistics
are included in the report e-mails.
[no] item station-count This command is supported when the NWA/WAC
is in controller mode. Determines whether or not
the station statistics are included in the report e-
mails.
[no] item wtp-tx This command is supported when the NWA/WAC
is in controller mode. Determines whether or not
the NWA/WAC’s outgoing traffic statistics are
included in the report e-mails.
[no] item wtp-rx This command is supported when the NWA/WAC
is in controller mode. Determines whether or not
the NWA/WAC’s incoming traffic statistics are
included in the report e-mails.
smtp-port <1..65535> Sets the SMTP service port.
no smtp-port Resets the SMTP service port configuration.
smtp-tls {tls|starttls} Sets how you want communications between the
SMTP mail server and the NWA/WAC to be
encrypted.
tls: to use Secure Sockets Layer (SSL) or
Transport Layer Security (TLS).
starttls: to upgrade a plain text connection to
a secure connection using SSL/TLS.
Table 74 Email Daily Report Commands (continued)
COMMAND DESCRIPTION
To Next Page
Loading...
