ZyXEL Communications nwa series - AP Management Commands

Chapter 7 AP Management
NWA/WAC Series CLI Reference Guide
46
7.2 AP Management Commands
The following table identifies the values required for many of these commands. Other input values
are discussed with the corresponding commands.
The following table describes the commands available for AP managment. You must use the
configure terminal command to enter the configuration mode before you can use these
commands.
Table 18 Input Values for General AP Management Commands
LABEL DESCRIPTION
ap_mac The Ethernet MAC address of the managed AP. Enter 6 hexadecimal pairs separated by
colons. You can use 0-9, a-z and A-Z.
slot_name The slot name for the AP’s on-board wireless LAN card. Use either slot1 or slot2. (Not
all NWA/WACs support 2 radio slots.)
profile_name The wireless LAN radio profile name. You may use 1-31 alphanumeric characters,
underscores(
_), or dashes (-), but the first character cannot be a number. This value is
case-sensitive.
ap_description The AP description. This is strictly used for reference purposes and has no effect on any
other settings. You may use 1-31 alphanumeric characters, underscores(
_), or dashes
(-), but the first character cannot be a number. This value is case-sensitive.
sta_mac The Ethernet MAC address of the managed station (or wireless client). Enter 6
hexadecimal pairs separated by colons. You can use 0-9, a-z and A-Z.
Table 19 Command Summary: AP Management
COMMAND DESCRIPTION
wlan slot_name Enters the sub-command mode for the specified radio on the
NWA/WAC.
[no] activate Eenables the specified radio. The no command disables the radio.
ap profile radio_profile_name Sets the radio (slot_name) to AP mode and assigns a created
radio profile to the radio.
output-power power Sets the output power (between 0 to 30 dBm) for the specified
radio.
repeater profile radio_profile_name Sets the specified radio (slot_name) to repeater mode and
assigns a created radio profile to the radio.
rootap profile radio_profile_name Sets the specified radio (slot_name) to root AP mode and assigns
a created radio profile to the radio.
ssid profile index ssid_profile_name Assigns an SSID profile to this radio. Requires an existing SSID
profile.
wds_profile wds_profile_name Selects the WDS profile the radio (in repeater or root AP mode)
uses to connect to a root AP or repeater.
wds_uplink {auto | manual bssid
mac_address}
Sets how the radio (in repeater mode) connect to a root AP or
repeater.
auto: to have the NWA/WAC automatically use the settings in the
applied WDS profile to connect to a root AP or repeater.
manual: to have the NWA/WAC connect to the root AP or repeater
with tbe specified MAC address. You need to configure the MAC
address of the root AP or repeater with which you want the NWA/
WAC to associate.
show wlan slot_name Displays the operating mode and profile settings for the specified
radio.