ZyXEL Communications nwa series - SSID Profile Example

Chapter 8 Wireless LAN Profiles
NWA/WAC Series CLI Reference Guide
57
8.3.1 SSID Profile Example
The following example creates an SSID profile with the name ‘ZyXEL’. It makes the assumption that
both the security profile (SECURITY01) and the MAC filter profile (MACFILTER01) already exist.
[no] hide Prevents the SSID from being publicly broadcast. Use the no
parameter to re-enable public broadcast of the SSID in this
profile.
By default this is disabled.
[no] l2isolation l2profile Assigns the specified layer-2 isolation profile to this SSID profile.
Use the no parameter to remove it.
By default, no layer-2 isolation profile is assigned.
[no] macfilter macfilterprofile Assigns the specified MAC filtering profile to this SSID profile. Use
the no parameter to remove it.
By default, no MAC filter is assigned.
qos wlan_qos Sets the type of QoS used by this SSID.
security securityprofile Assigns the specified security profile to this SSID profile.
ssid Sets the SSID. This is the name visible on the network to wireless
clients. Enter up to 32 characters, spaces and underscores are
allowed.
The default SSID is ‘ZyXEL’.
uplink-rate-limit data_rate Sets the maximum outgoing transmission data rate (either in
mbps or kbps) on a per-station basis.
[no] vlan-id <1..4094> Applies to each SSID profile. If the VLAN ID is equal to the AP’s
native VLAN ID then traffic originating from the SSID is not
tagged.
The default VLAN ID is 1.
Table 24 Command Summary: SSID Profile (continued)
COMMAND DESCRIPTION
Router(config)# wlan-ssid-profile SSID01
Router(config-ssid-radio)# ssid ZyXEL
Router(config-ssid-radio)# qos wmm
Router(config-ssid-radio)# security SECURITY01
Router(config-ssid-radio)# macfilter MACFILTER01
Router(config-ssid-radio)# exit
Router(config)#