ZyXEL Communications nwa series - Page 56

Chapter 8 Wireless LAN Profiles
NWA/WAC Series CLI Reference Guide
56
The following table describes the commands available for SSID profile managment. You must use
the
configure terminal command to enter the configuration mode before you can use these
commands.
wlan_qos Sets the type of QoS the SSID should use.
disable: Turns off QoS for this SSID.
wmm: Turns on QoS for this SSID. It automatically assigns Access Categories to
packets as the device inspects them in transit.
wmm_be: Assigns the “best effort” Access Category to all traffic moving through
the SSID regardless of origin.
wmm_bk: Assigns the “background” Access Category to all traffic moving
through the SSID regardless of origin.
wmm_vi: Assigns the “video” Access Category to all traffic moving through the
SSID regardless of origin.
wmm_vo: Assigns the “voice” Access Category to all traffic moving through the
SSID regardless of origin.
securityprofile Assigns an existing security profile to the SSID profile. You may use 1-31
alphanumeric characters, underscores (
_), or dashes (-), but the first character
cannot be a number. This value is case-sensitive.
macfilterprofile Assigns an existing MAC filter profile to the SSID profile. You may use 1-31
alphanumeric characters, underscores (
_), or dashes (-), but the first character
cannot be a number. This value is case-sensitive.
description2 Sets the description of the profile. You may use up to 60 alphanumeric
characters, underscores (
_), or dashes (-). This value is case-sensitive.
Table 23 Input Values for General SSID Profile Commands (continued)
LABEL DESCRIPTION
Table 24 Command Summary: SSID Profile
COMMAND DESCRIPTION
show wlan-ssid-profile {all | rule_count |
[ssid_profile_name]}
Displays the SSID profile(s).
all: Displays all profiles.
rule_count: Displays how many SSID profiles are created on the
NWA/WAC.
ssid_profile_name: Displays the specified profile.
wlan-ssid-profile rename ssid_profile_name1
ssid_profile_name2
Gives an existing SSID profile (ssid_profile_name1) a new
name (ssid_profile_name2).
[no] wlan-ssid-profile ssid_profile_name Enters configuration mode for the specified SSID profile. Use the
no parameter to remove the specified profile.
[no] block-intra Enables intra-BSSID traffic blocking. Use the no parameter to
disable it in this profile.
By default this is disabled.
description description Sets a descriptive name for this profile.
downlink-rate-limit data_rate Sets the maximum incoming transmission data rate (either in
mbps or kbps) on a per-station basis.
exit Exits configuration mode for this profile.