Chapter 18 File Manager
NWA/WAC Series CLI Reference Guide
106
Note: You only need to use the atuk or atur command if the recovery image is damaged.
Figure 18 atuk Command for Restoring the Recovery Image
4 Enter Y and wait for the “Starting XMODEM upload” message before activating XMODEM upload on
your terminal.
Figure 19 Starting Xmodem Upload
5 This is an example Xmodem configuration upload using HyperTerminal. Click Transfer, then Send
File to display the following screen.
Figure 20 Example Xmodem Upload
6 Wait for about three and a half minutes for the Xmodem upload to finish.
Figure 21 Recovery Image Upload Complete
Type the firmware file's
location, or click Browse to
search for it.
Choose the 1K Xmodem
protocol.
Then click Send.
To Next Page
Loading...
