Chapter 5 Interfaces
NWA/WAC Series CLI Reference Guide
39
The following table describes the commands available for VLAN interface managment. You must use
the
configure terminal command to enter the configuration mode before you can use these
commands.
Table 12 Command Summary: VLAN Interface Profile
COMMAND DESCRIPTION
[no] interface config_interface Enters configuration mode for the specified interface. Use the no
parameter to remove the specified profile.
vlanid <1..4094> <tag|untag> Sets the interface’s VLAN identification number and sets it to
send tagged or untagged packets.
[no] ip address addr netmask Sets the interface’s IP address and subnet mask address. Use the
no parameter to remove these values from this interface.
[no] ip address dhcp [metric <0..15>] Sets the interface to use the DHCP to acquire an IP address.
Enter the metric (priority) of the gateway (if any) on this
interface. The NWA/WAC decides which gateway to use based on
this priority. The lower the number, the higher the priority. If two
or more gateways have the same priority, the NWA/WAC uses the
one that was configured first.
mtu <576..1500> Sets the maximum size of each data packet, in bytes, that can
move through this interface. If a larger packet arrives, the NWA/
WAC divides it into smaller fragments.
no mtu Disables the mtu feature for this interface.
[no] ip gateway gateway [metric <0..15>] Enter the IP address of the gateway. The NWA/WAC sends
packets to the gateway when it does not know how to route the
packet to its destination. The gateway should be on the same
network as the interface.
Also enter the metric (priority) of the gateway (if any) on this
interface. The NWA/WAC decides which gateway to use based on
this priority. The lower the number, the higher the priority. If two
or more gateways have the same priority, the NWA/WAC uses the
one that was configured first.
no vlan-id Removes the VLAN ID from the interface.
upstream <0..1048576> Sets the maximum amount of traffic, in kilobits per second, the
NWA/WAC can send through the interface to the network.
no upstream Disables the upstream bandwidth limit.
downstream <0..1048576> Sets the maximum amount of traffic, in kilobits per second, the
NWA/WAC can receive from the network through the interface.
no downstream Disables the downstream bandwidth limit.
description description Sets the description of this interface. It is not used elsewhere.
You can use alphanumeric and ()+/:=?!*#@$_%- characters,
and it can be up to 60 characters long.
no description Removes the VLAN description.
[no] shutdown Exits this sub-command mode, saving all changes but without
enabling the VLAN.
[no] ip helper-address Enables the IP helper address.
exit Exits configuration mode for this interface.
To Next Page
Loading...
