Chapter 7 Monitor
ZyWALL USG Series User’s Guide
201
Each field is described in the following table.
Table 38 Monitor > System Status > Interface Status
LABEL DESCRIPTION
Interface Status
If an Ethernet interface does not have any physical ports associated with it, its entry is displayed in light gray text.
Name This field displays the name of each interface. If there is an Expand icon (plus-sign) next to the
name, click this to look at the status of virtual interfaces on top of this interface.
Port/Binding This field displays the physical port number.
Status This field displays the current status of each interface. The possible values depend on what
type of interface it is.
For Ethernet interfaces:
• Inactive - The Ethernet interface is disabled.
• Down - The Ethernet interface does not have any physical ports associated with it or the
Ethernet interface is enabled but not connected.
• Speed / Duplex - The Ethernet interface is enabled and connected. This field displays the
port speed and duplex setting (Full or Half).
For cellular (mobile broadband) interfaces, see Section 7.13 on page 218 the Web Help for the
status that can appear.
For the auxiliary interface:
• Inactive - The auxiliary interface is disabled.
• Connected - The auxiliary interface is enabled and connected.
• Disconnected - The auxiliary interface is not connected.
For virtual interfaces, this field always displays Up. If the virtual interface is disabled, it does not
appear in the list.
For VLAN and bridge interfaces, this field always displays Up. If the VLAN or bridge interface is
disabled, it does not appear in the list.
For PPP interfaces:
• Connected - The PPP interface is connected.
• Disconnected - The PPP interface is not connected.
If the PPP interface is disabled, it does not appear in the list.
For WLAN interfaces:
• Up - The WLAN interface is enabled.
• Down - The WLAN interface is disabled.
HA Status This field displays the status of the interface in the virtual router.
• Active - This interface is the master interface in the virtual router.
• Stand-By - This interface is a backup interface in the virtual router.
• Fault - This VRRP group is not functioning in the virtual router right now. For example, this
might happen if the interface is down.
• n/a - Device HA is not active on the interface.
Zone This field displays the zone to which the interface is assigned.
IP Addr/Netmask This field displays the current IP address and subnet mask assigned to the interface. If the IP
address and subnet mask are 0.0.0.0, the interface is disabled or did not receive an IP address
and subnet mask via DHCP.
If this interface is a member of an active virtual router, this field displays the IP address it is
currently using. This is either the static IP address of the interface (if it is the master) or the
management IP address (if it is a backup).
To Next Page
Loading...
