Installation manual 2N® IP Verso
General Mounting Principles
•
•
•
•
Caution
Before starting the mechanical installation on a selected place, make sure
carefully that the preparations connected with it (drilling, wall cutting) cannot
damage the electrical, gas, water and other existing wires and pipes.
The warranty does not apply to the product defects and failures arisen as a result
of improper mounting (in contradiction herewith). The manufacturer is neither
liable for damage caused by theft within an area that is accessible after the
attached electric lock is switched. The product is not designed as a burglar
protection device except when used in combination with a standard lock, which
has the security function.
When the proper mounting instructions are not met, water might get in and
destroy the electronics. It is because the communicator circuits are under
continuous voltage and water infiltration causes an electro-chemical reaction. The
manufacturer’s warranty shall be void for products damaged in this way!
Do not remove the plastic film on the seal inside the frame, otherwise water may
leak and damage the electronic components.
•
•
Tip
Select flush mounting where possible to make your product elegant looking, more
vandal resistant and more secure.
You are advised to buy the flush mounting boxes in advance and commission your
building company to do the masonry for you. This approach helps you put your
intercom exactly in the vertical position.
To Next Page
Loading...
