360 Vision H7016

To Next Page

To Previous Page

Chapter 4. H7016 Setup

4-21

Pink – Motion detection (MOT) + Sensor detection (SENS) Recording

The unit does not record unless there is a motion event detected or a sensor triggered.

If the ‘motion/event menu configuration is set to ‘OFF’ the DVR system doesn’t record at

any time nor trigger any event even if there is motion or a sensor event.

Tip

System will record with either Continuous or Motion detection mode when it is set to

‘CONT +MOT’ in the schedule. Any mode that has sensor or event the system will

then change to ‘Intensive’ recording mode once it detects event.

360 Vision H7016 - Page 75