Since the product is designed to record
video data on the hard disk, an error in the
hard disk or other miscellaneous errors
might prevent the product from recording
properly. Periodic maintenance is required
for proper operation of the product
The product is designed for users to
configure their own interface. However a
user configuration error could lead to
operation malfunction. This product should
be set up by certified installers
only.
Since the product is connected - and tightly
coupled - to exterior accessories (camera,
sensor, LAN, Hard Disk, etc.), there is a
risk of malfunction from external causes.
Ensure periodic maintenance by the
certified installers
The product may not work properly if the
power source is unstable or/and if electric
shock occurs. Make sure the correct rated
power is available.
The product is designed to be proof
against electric power failures; however,
damage may occur as a result of power
failure. Current data may be damaged or
data might not be recorded. Make sure to
use an Uninterruptible Power Supply
(UPS).
In this product, 1 Kbyte equals 1,024 bytes,
1M byte equals 1,024,000 bytes and 1G
byte equals 1,024,000,000 bytes.
Denotes requirements and limitations in operation. Users are
recommended to read the relevant details carefully so as to operate
the product properly and without harm.
To Next Page
Loading...