1-11
The port state change delay takes effect when the port goes down but not when the port goes up.
Table 1-11 set the port state change delay
Operation Command Remarks
Enter system view
system-view
—
Enter Ethernet interface
view
interface interface-type
interface-number
—
Set the port state change
delay
link-delay delay-time
Required
Defaults to 0, which indicates that no
delay is introduced.
The delay configured in this way does not take effect for ports in DLDP down state. For information
about the DLDP down state, refer to DLDP.
To Next Page
Loading...