3Com 4210 9-Port - Table of Contents

i
Table of Contents
1 Boot ROM and Host Software Loading ···································································································1-1
Introduction to Loading Approaches ·······································································································1-1
Local Boot ROM and Software Loading··································································································1-1
BOOT Menu ····································································································································1-2
Loading by XModem through Console Port ····················································································1-3
Loading by TFTP through Ethernet Port ·························································································1-7
Loading by FTP through Ethernet Port····························································································1-9
Remote Boot ROM and Software Loading ···························································································1-11
Remote Loading Using FTP··········································································································1-11
Remote Loading Using TFTP········································································································1-15
2 Basic System Configuration and Debugging ·························································································2-1
Basic System Configuration····················································································································2-1
Displaying the System Status ·················································································································2-1
Debugging the System····························································································································2-2
Enabling/Disabling System Debugging···························································································2-2
Displaying Debugging Status ··········································································································2-3
Displaying Operating Information about Modules in System ··························································2-3
Command Alias Configuration ················································································································2-1
Introduction······································································································································2-1
Configuring Command Alias············································································································2-1
3 Network Connectivity Test ·······················································································································3-1
Network Connectivity Test ······················································································································3-1
ping··················································································································································3-1
tracert···············································································································································3-1
4 Device Management··································································································································4-1
Introduction to Device Management·······································································································4-1
Device Management Configuration·········································································································4-1
Device Management Configuration Tasks ······················································································4-1
Rebooting the Ethernet Switch········································································································4-1
Scheduling a Reboot on the Switch ································································································4-2
Configuring Real-time Monitoring of the Running Status of the System·········································4-2
Specifying the APP to be Used at Reboot·······················································································4-2
Upgrading the Boot ROM················································································································4-3
Enabling Auto Power Down on the 1000 Mbps Uplink Port····························································4-3
Identifying and Diagnosing Pluggable Transceivers ·······································································4-3
Displaying the Device Management Configuration·················································································4-5
Remote Switch APP Upgrade Configuration Example ···········································································4-6
5 Scheduled Task Configuration·················································································································5-1
What Is a Scheduled Task······················································································································5-1
Configuring a Scheduled Task················································································································5-1
Configuration Prerequisites·············································································································5-1