2-2
Manual application mode
You can use the apply command to manually apply a QoS profile to a port.
QoS Profile Configuration
Table 2-1 QoS profile configuration tasks
Operation Description Related section
Configure a QoS Profile Required Section Configuring a QoS Profile
Configure to apply a QoS Profile
dynamically
Optional Section
Applying a QoS Profile
Apply a QoS Profile manually Optional Section Applying a QoS Profile
Configuring a QoS Profile
Configuration prerequisites
z The ACL rules used for traffic classification are defined. Refer to the ACL module of this manual for
information about defining ACL rules.
z The type and number of actions in the QoS profile are specified.
Configuration procedure
Table 2-2 Configure a QoS profile
Operation Command Description
Enter system view
system-view
—
Create a QoS profile and
enter QoS profile view
qos-profile profile-name
Required
If the specified QoS profile
already exists, you enter the
QoS profile view directly.
Configure traffic policing
traffic-limit inbound acl-rule
target-rate [ burst-bucket
burst-bucket-size ] [ conform
con-action ] [ exceed
exceed-action ] [ meter-statistic ]
Optional
Configure packet filtering
packet-filter inbound acl-rule
Optional
Refer to the ACL module of this
manual for information about
packet filtering.
Configure priority marking
traffic-priority inbound acl-rule
{ dscp dscp-value | cos cos-value |
local-precedence pre-value }*
Optional
Applying a QoS Profile
You can configure to apply a QoS profile dynamically or simply apply a QoS profile manually.
To Next Page
Loading...