1-12
Setting to Output System Information to a Log Host
Table 1-12 Set to output system information to a log host
Operation Command Description
Enter system view
system-view
—
Enable the information
center
info-center enable
Optional
Enabled by default.
Enable system information
output to a log host
info-center loghost
host-ip-addr [ channel
{ channel-number |
channel-name } | facility
local-number ]*
Required
By default, the switch does not
output information to the log host.
After you configure the switch to
output information to the log host,
the switch uses information
channel 2 by default.
Configure the source
interface through which log
information is sent to the log
host
info-center loghost source
interface-type interface-number
Optional
By default, no source interface is
configured, and the system
automatically selects an interface
as the source interface.
Configure the output rules
of system information
info-center source
{ modu-name | default }
channel { channel-number |
channel-name } [ { log | trap |
debug } { level severity | state
state } ]*
Optional
Refer to
Table 1-8 for the default
output rules of system information.
Set the format of the time
stamp to be sent to the log
host
info-center timestamp
loghost { date | no-year-date |
none }
Optional
By default, the time stamp format
of the information output to the log
host is date.
Be sure to set the correct IP address when using the info-center loghost command. A loopback IP
address will cause an error message prompting that this address is invalid.
Setting to Output System Information to the Trap Buffer
Table 1-13 Set to output system information to the trap buffer
Operation Command Description
Enter system view
system-view
—
Enable the information center
info-center enable
Optional
Enabled by default.
To Next Page
Loading...