1-11
Operation Command Description
Set the format of time stamp
in the output information
info-center timestamp { log |
trap | debugging } { boot | date
| none }
Optional
By default, the time stamp format
of the log and trap output
information is date, and that of the
debugging output information is
boot.
z When there are multiple Telnet users or dumb terminal users, they share some configuration
parameters including module filter, language and severity level threshold. In this case, change to
any such parameter made by one user will also be reflected on all other user terminals.
z To view debugging information of specific modules, you need to set the information type as debug
when setting the system information output rules, and enable debugging for corresponding
modules through the debugging command.
Enabling system information display on a monitor terminal
After setting to output system information to a monitor terminal, you need to enable the associated
display function in order to display the output information on the monitor terminal.
Table 1-11 Enable the display of system information on a monitor terminal
Operation Command Description
Enable the debugging/log/trap
information terminal display function
terminal monitor
Optional
Enabled by default
Enable debugging information
terminal display function
terminal debugging
Optional
Disabled by default
Enable log information terminal
display function
terminal logging
Optional
Enabled by default
Enable trap information terminal
display function
terminal trapping
Optional
Enabled by default
Make sure that the debugging/log/trap information terminal display function is enabled (use the
terminal monitor command) before you enable the corresponding terminal display function by using
the terminal debugging, terminal logging, or terminal trapping command.
To Next Page
Loading...