1-5
MAC Address Table Management
MAC Address Table Management Configuration Task List
Complete the following tasks to configure MAC address table management:
Task Remarks
Configuring a MAC Address Entry Required
Setting the MAC Address Aging Timer Optional
Setting the Maximum Number of MAC Addresses a Port Can Learn Optional
Configuring a MAC Address Entry
You can add, modify, or remove a MAC address entry, remove all MAC address entries concerning a
specific port, or remove specific type of MAC address entries (dynamic or static MAC address entries).
You can add a MAC address entry in either system view or Ethernet port view.
Adding a MAC address entry in system view
Follow these steps to add a MAC address entry in system view:
To do… Use the command… Remarks
Enter system view
system-view
—
Add a MAC address entry
mac-address { static |
dynamic | blackhole }
mac-address interface
interface-type interface-number
vlan vlan-id
Required
z When you add a MAC address entry, the port specified by the interface argument must belong to
the VLAN specified by the vlan argument in the command. Otherwise, you will fail to add this MAC
address entry. By default, all ports belong to VLAN 1..
z If the VLAN specified by the vlan argument is a dynamic VLAN, after a static MAC address is
added, it will become a static VLAN.
Adding a MAC address entry in Ethernet port view
Follow these steps to add a MAC address entry in Ethernet port view:
To do… Use the command… Remarks
Enter system view
system-view
—
Enter Ethernet port view
interface interface-type
interface-number
—
To Next Page
Loading...