2-5
To do… Use the command… Remarks
Enter system view
system-view
—
Enter Ethernet port view
interface interface-type
interface-number
—
Configure the port link type as
Trunk
port link-type trunk
Required
Allow the specified VLANs to
pass through the current Trunk
port
port trunk permit vlan
{ vlan-id-list | all }
Required
By default, all Trunk ports only
allow packets of VLAN 1 to
pass.
Configure the default VLAN for
the Trunk port
port trunk pvid vlan vlan-id
Optional
VLAN 1 is the default by
default.
z To convert a Trunk port into a Hybrid port (or vice versa), you need to use the Access port as a
medium. For example, the Trunk port has to be configured as an Access port first and then a Hybrid
port.
z The default VLAN IDs of the Trunk ports on the local and peer devices must be the same.
Otherwise, packets cannot be transmitted properly.
Displaying and Maintaining Port-Based VLAN
To do… Use the command… Remarks
Display the hybrid or trunk ports display port { hybrid | trunk } Available in any view.
Port-Based VLAN Configuration Example
Network requirements
z As shown in Figure 2-1, Switch A and Switch B each connect to a server and a workstation (Host).
z For data security concerns, the two servers are assigned to VLAN 101 with the descriptive string
being “DMZ”, and the PCs are assigned to VLAN 201.
z The devices within each VLAN can communicate with each other but that in different VLANs
cannot communicate with each other directly.
To Next Page
Loading...