1-1
1 Port Isolation Configuration
Port Isolation Overview
Through the port isolation feature, you can add the ports to be controlled into an isolation group to
isolate the Layer 2 and Layer 3 data between each port in the isolation group. Thus, you can construct
your network in a more flexible way and improve your network security.
Currently, you can create only one isolation group on a Switch 4210. The number of Ethernet ports in an
isolation group is not limited.
An isolation group only isolates the member ports in it.
Port Isolation Configuration
You can perform the following operations to add an Ethernet ports to an isolation group, thus isolating
Layer 2 and Layer 3 data among the ports in the isolation group.
Table 1-1 Configure port isolation
Operation Command Description
Enter system view
system-view
—
Enter Ethernet port view
interface interface-type
interface-number
—
Add the Ethernet port to the
isolation group
port isolate
Required
By default, an isolation group
contains no port.
To Next Page
Loading...