1-7
z You can configure a login header only when the service type is stelnet. For configuration of service
types, refer to
Specifying a Service Type for an SSH User.
z For details of the header command, refer to the corresponding section in Login Command.
Configuring the SSH Server to Be Compatible with SSH1 Clients
Follow these steps to configure the SSH server to be compatible with SSH1 clients:
To do... Use the command... Remarks
Enter system view
system-view
—
Configure the SSH server to be
compatible with SSH1 clients
ssh server
compatible-ssh1x
enable
Optional
By default, the SSH server is
compatible with SSH1 clients.
Generating/Destroying Key Pairs
This configuration task lets you generate or destroy a key pair. You must generate an RSA and DSA key
pair on the server for an SSH client to log in successfully. When generating a key pair, you will be
prompted to enter the key length in bits, which is between 512 and 2048. The default length is 1024. In
case a key pair already exists, the system will ask whether to replace the existing key pair.
Table 1-5 Follow these steps to create or destroy key pairs:
To do... Use the command... Remarks
Enter system view
system-view
—
Generate an RSA key pair
public-key local create rsa
Required
By default, no RSA key pair is
created.
Destroy the RSA key pair
public-key local destroy rsa
Optional
Use the command to destroy
the generated RSA key pair.
Generate a DSA key pair
public-key local create dsa
Required
By default, no DSA key pair is
created.
Destroy the DSA key pair
public-key local destroy dsa
Optional
Use the command to destroy
the generated DSA key pair.
To Next Page
Loading...