1-18
Operation Command Description
Display the topology of the
current cluster
display cluster current-topology
[ mac-address mac-address1
[ to-mac-address mac-address2 ] |
member-id member-id1
[ to-member-id member-id2 ] ]
Display the information about
the base topology of the cluster
display cluster base-topology
[ mac-address mac-address | member
member-id ]
Display the information about
all the devices in the base
cluster topology
display cluster base-members
be executed in any
view.
When you display the cluster topology information, the devices attached to the switch that is listed in the
backlist will not be displayed.
Configure cluster device blacklist
Follow these steps to configure the cluster device blacklist on a management device:
Operation Command Description
Enter system view
system-view
—
Enter cluster view
cluster
—
Add the MAC address of a
specified device to the cluster
blacklist
black-list add-mac
mac-address
Optional
By default, the cluster blacklist
is empty.
Delete the specified MAC
address from the cluster
blacklist
black-list delete-mac
mac-address
Optional
Delete a device from the cluster
add this device to the cluster
blacklist
delete-member member-id
[ to-black-list ]
Optional
Displays the information about
the devices in the cluster
blacklist
display cluster black-list
Optional
This command can be
executed in any view.
Configuring the Cluster Synchronization Function
After a cluster is established, to simplify the access and management to the cluster, you can
synchronize the SNMP configurations on the management device and the local user configurations to
the member devices of the cluster by configuring the cluster synchronization function.
To Next Page
Loading...