3Com 4210 9-Port - Configuring the Sending Mode of Accounting Start Requests

2-14
use the assigned Attribute 28, idle-timeout. You can configure the attribute ignoring function on NAS 2
to ignore Attribute 28.
Figure 2-1 Network diagram for the RADIUS authorization attribute ignoring function
Host 1
Switch
RADIUS server
Host 2
IP network
NAS 1
NAS 2
Follow these steps to configure the RADIUS authorization attribute ignoring function:
To do… Use the command… Remarks
Enter system view
system-view
—
Create a RADIUS
scheme and enter
its view
radius scheme
radius-scheme-name
Required
By default, a RADIUS scheme named
"system" has already been created in
the system.
Configure the
RADIUS
authorization
attribute ignoring
function
attribute-ignore { standard |
vendor vendor-id } type type-value
Required
Disabled by default.
In a RADIUS scheme, you can configure:
z One standard attribute ignoring command
z One proprietary attribute ignoring command per vendor
z Up to three attribute ignoring commands in total
Configuring the Sending Mode of Accounting Start Requests
Table 2-13 Configure the sending mode of accounting start requests
Operation Command Remarks
Enter system view
system-view
—
Create a RADIUS scheme and
enter its view
radius scheme
radius-scheme-name
—