1-13
Operation Command Description
Enable system information
output to the trap buffer
info-center trapbuffer
[channel { channel-number |
channel-name } | size
buffersize]*
Optional
By default, the switch uses
information channel 3 to output
trap information to the trap
buffer, which can holds up to
256 items by default.
Configure the output rules of
system information
info-center source
{ modu-name | default }
channel { channel-number |
channel-name } [ { log | trap |
debug } { level severity | state
state } ]*
Optional
Refer to
Table 1-8 for the
default output rules of system
information.
Set the format of time stamp in
the output information
info-center timestamp { log |
trap | debugging } { boot |
date | none }
Optional
By default, the time stamp
format of the output trap
information is date.
Setting to Output System Information to the Log Buffer
Table 1-14 Set to output system information to the log buffer
Operation Command Description
Enter system view
system-view
—
Enable the information center
info-center enable
Optional
Enabled by default.
Enable information output to
the log buffer
info-center logbuffer
[ channel { channel-number |
channel-name } | size
buffersize ]*
Optional
By default, the switch uses
information channel 4 to output
log information to the log buffer,
which can holds up to 512
items by default.
Configure the output rules of
system information
info-center source
{ modu-name | default }
channel { channel-number |
channel-name } [ { log | trap |
debug } { level severity | state
state } ]*
Optional
Refer to
Table 1-8 for the
default output rules of system
information.
Set the format of time stamp in
the output information
info-center timestamp { log |
trap | debugging } { boot |
date | none }
Optional
By default, the time stamp
format of the output log
information is date.
Setting to Output System Information to the SNMP NMS
Table 1-15 Set to output system information to the SNMP NMS
Operation Command Description
Enter system view
system-view
—
To Next Page
Loading...