3Com 4210 9-Port - Configuring Traffic Mirroring

1-23
Configuration procedure
Table 1-26 Enable the burst function
Operation Command Description
Enter system view
system-view
—
Enable the burst
function
burst-mode enable
Required
By default, the burst function is
disabled.
Configuration example
Enable the burst function.
Configuration procedure:
<Sysname> system-view
[Sysname] burst-mode enable
Configuring Traffic Mirroring
Refer to section Traffic Mirroring for information about traffic mirroring.
Configuration prerequisites
z The ACL rules for traffic classification are defined. Refer to the ACL module of this manual for
information about defining ACL rules.
z The destination mirroring port is determined.
Configuration procedure
You can configure traffic mirroring on all the packets matching specific ACL rules, or on packets that
match specific ACL rules and are of a VLAN, or pass a port.
Table 1-27 Configure traffic mirroring globally
Operation Command Description
Enter system view
system-view
—
Enter Ethernet port view of the
destination port
interface interface-type
interface-number
—
Define the current port as the
destination port
monitor-port
Required
Exit current view
quit
—
Reference ACLs for identifying
traffic flows and perform traffic
mirroring for packets that match.
mirrored-to inbound acl-rule
{ cpu | monitor-interface }
Required
Table 1-28 Configure traffic mirroring for a VLAN
Operation Command Description
Enter system view
system-view
—
Enter Ethernet port view of the
interface interface-type
—