3Com 4210 9-Port - Configuration Example

1-3
Configuration Example
Network requirements
For a user to manage Switch A remotely through Telnet, these requirements are to be met: Switch A has
an IP address, and the remote Telnet user is reachable.
You need to configure the switch as follows:
z Assigning an IP address to the management VLAN interface on Switch A
z Configuring the default route
Network diagram
Figure 1-1 Network diagram for management VLAN configuration
RS-232 serial
interface
Console port
Console cable
Vlan- interface10
1.1.1.1/24
Switch A
Telnet user
Ethernet1/1
1.1.1.2/24
Router
Current
user
Configuration procedure
Perform the following configurations after the current user logs in to Switch A through the Console port.
# Enter system view.
<SwitchA> system-view
# Create VLAN 10 and configure VLAN 10 as the management VLAN.
[SwitchA] vlan 10
[SwitchA-vlan10] quit
[SwitchA] management-vlan 10
# Create the VLAN 10 interface and enter VLAN interface view.
[SwitchA] interface vlan-interface 10
# Configure the IP address of VLAN 10 interface as 1.1.1.1/24.