3Com 4210 9-Port - Displaying and Debugging Smart Link; Smart Link Configuration Example; Implementing Link Redundancy Backup

1-6
Displaying and Debugging Smart Link
After the above-mentioned configuration, you can use the following display commands in any view to
view the Smart Link group information and the statistics information of flush messages received and
processed by current device, so as to verify the configuration.
Use the reset command in user view to clear flush message statistics.
Table 1-5 Display and debug Smart Link
Operation Command Remarks
Display the information of a Smart Link
group
display smart-link group
{ group-id | all }
Display the statistics information of
flush messages received and
processed by the current device
display smart-link flush
You can execute the
display command in any
view.
Clear flush message statistics
reset smart-link packets
counter
You can execute the
reset command in user
view.
Smart Link Configuration Example
Implementing Link Redundancy Backup
Network requirements
As shown in Figure 1-3, Switch A is a 3Com switch 4210. Switch C, Switch D and Switch E support
Smart Link. Configure Smart Link feature to provide remote PCs with reliable access to the server.
Network diagram
Figure 1-3 Network diagram for Smart Link configuration
Switch A
Eth1/0/1 Eth1/0/2
Switch C
Server
Eth1/0/1
Eth1/0/2 Eth1/0/2
PC
Switch D
Switch E
Eth1/0/3Eth1/0/2
Eth1/0/1