2-7
[SwitchA-Ethernet1/0/3] port trunk permit vlan 101
[SwitchA-Ethernet1/0/3] port trunk permit vlan 201
# Configure Ethernet1/0/10 of Switch B.
[SwitchB] interface Ethernet 1/0/10
[SwitchB-Ethernet1/0/10] port link-type trunk
[SwitchB-Ethernet1/0/10] port trunk permit vlan 101
[SwitchB-Ethernet1/0/10] port trunk permit vlan 201
Troubleshooting Ethernet Port Configuration
Symptom: Fail to configure the default VLAN ID of an Ethernet port.
Solution: Take the following steps.
z Use the display interface or display port command to check if the port is a trunk port or a hybrid
port.
z If the port is not a trunk or hybrid port, configure it to be a trunk or hybrid port.
z Configure the default VLAN ID of the port.
For information about the display interface command, refer to Port Basic Configuration in this manual.
To Next Page
