3Com 4210 9-Port - Creating an ISP Domain and Configuring Its Attributes

2-2
Task Remarks
Cutting Down User Connections Forcibly Optional
Creating an ISP Domain and Configuring Its Attributes
Table 2-3 Create an ISP domain and configure its attributes
Operation Command Remarks
Enter system view
system-view
—
Configure the form of the
delimiter between the user
name and the ISP domain
name
domain delimiter { at | dot }
Optional
By default, the delimiter
between the user name and the
ISP domain name is “@”.
Create an ISP domain or set an
ISP domain as the default ISP
domain
domain { isp-name | default
{ disable | enable isp-name } }
Required
If no ISP domain is set as the
default ISP domain, the ISP
domain "system" is used as the
default ISP domain.
Set the status of the ISP
domain
state { active | block }
Optional
By default, an ISP domain is in
the active state, that is, all the
users in the domain are allowed
to request network service.
Set the maximum number of
access users that the ISP
domain can accommodate
access-limit { disable |
enable max-user-number }
Optional
By default, there is no limit on
the number of access users
that the ISP domain can
accommodate.
Set the idle-cut function
idle-cut { disable | enable
minute flow }
Optional
By default, the idle-cut function
is disabled.
Set the accounting-optional
switch
accounting optional
Optional
By default, the
accounting-optional switch is
off.
Set the messenger function
messenger time { enable limit
interval | disable }
Optional
By default, the messenger
function is disabled.
Set the self-service server
location function
self-service-url { disable |
enable url-string }
Optional
By default, the self-service
server location function is
disabled.
Note that:
z On an S4210 series switch, each access user belongs to an ISP domain. You can configure up to
16 ISP domains on the switch. When a user logs in, if no ISP domain name is carried in the user
name, the switch assumes that the user belongs to the default ISP domain.