2-22
Operation Command Remarks
Create a RADIUS scheme and
enter its view
radius scheme
radius-scheme-name
Required
By default, a RADIUS scheme
named "system" has already
been created in the system.
Set the response timeout time
of RADIUS servers
timer response-timeout
seconds
Optional
By default, the response timeout
time of RADIUS servers is three
seconds.
Set the time that the switch
waits before it try to
re-communicate with primary
server and restore the status of
the primary server to active
timer quiet minutes
Optional
By default, the switch waits five
minutes before it restores the
status of the primary server to
active.
Set the real-time accounting
interval
timer realtime-accounting
minutes
Optional
By default, the real-time
accounting interval is 12 minutes.
Enabling Sending Trap Message when a RADIUS Server Goes Down
Table 2-22 Specify to send trap message when a RADIUS server goes down
Operation Command Remarks
Enter system view
system-view
—
Enable the sending of trap
message when a RADIUS
server is down
radius trap
{ authentication-server-down |
accounting-server-down }
Optional
By default, the switch does not
send trap message when a
RADIUS server is down.
z This configuration takes effect on all RADIUS schemes.
z The switch considers a RADIUS server as being down if it has tried the configured maximum times
to send a message to the RADIUS server but does not receive any response.
Enabling the User Re-Authentication at Restart Function
The user re-authentication at restart function applies only to the environment where the RADIUS
authentication/authorization and accounting server is CAMS.
To Next Page
Loading...