3Com 4210 9-Port - Page 154

To Next Page

To Previous Page

1-10

Network diagram

Figure 1-1 Network diagram for link aggregation configuration

Configuration procedure

The following only lists the configuration on Switch A; you must perform the similar configuration on

Switch B to implement link aggregation.

1) Adopting manual aggregation mode

# Create manual aggregation group 1.

<Sysname> system-view

[Sysname] link-aggregation group 1 mode manual

# Add Ethernet1/0/1 through Ethernet1/0/3 to aggregation group 1.

[Sysname] interface Ethernet1/0/1

[Sysname-Ethernet1/0/1] port link-aggregation group 1

[Sysname-Ethernet1/0/1] quit

[Sysname] interface Ethernet1/0/2

[Sysname-Ethernet1/0/2] port link-aggregation group 1

[Sysname-Ethernet1/0/2] quit

[Sysname] interface Ethernet1/0/3

[Sysname-Ethernet1/0/3] port link-aggregation group 1

2) Adopting static LACP aggregation mode

# Create static aggregation group 1.