1-16
Task Remarks
Configuring the Timeout Time Factor Optional
Configuring the Maximum Transmitting
Rate on the Current Port
Optional
The default value is recommended.
Configuring the Current Port as an Edge
Port
Optional
Setting the Link Type of a Port to P2P Optional
Enabling MSTP
Required
To prevent network topology jitter
caused by other related configurations,
you are recommended to enable MSTP
after performing other configurations.
Configuring an MST Region Required
Configuring How a Port Recognizes and
Sends MSTP Packets
Optional
Configuring the Timeout Time Factor Optional
Configuring the Maximum Transmitting
Rate on the Current Port
Optional
The default value is recommended.
Configuring the Current Port as an Edge
Port
Optional
Configuring the Path Cost for a Port Optional
Configuring Port Priority Optional
Configuring
Leaf Nodes
Setting the Link Type of a Port to P2P Optional
Performing mCheck Operation Optional
Configuring Guard Functions Optional
Configuring Digest Snooping Optional
Configuring Rapid Transition Optional
Configuring VLAN-VPN Tunnel Optional
MSTP Maintenance Configuration Optional
Enabling Trap Messages Conforming to 802.1d Standard Optional
In a network containing switches with both GVRP and MSTP enabled, GVRP messages travel along
the CIST. If you want to advertise a VLAN through GVRP, be sure to map the VLAN to the CIST (MSTI
0) when configuring the VLAN-to-instance mapping table.
To Next Page
Loading...