1-16
Table 1-13 Mark the priority for packets that are of a VLAN and match specific ACL rules
Operation Command Description
Enter system view
system-view
—
Mark the priorities for
packets matching specific
ACL rules
traffic-priority vlan vlan-id inbound
acl-rule { dscp dscp-value | cos
cos-value | local-precedence
pre-value }*
Required
Table 1-14 Mark the priority for packets passing a port and matching specific ACL rules
Operation Command Description
Enter system view
system-view
—
Enter Ethernet port view
interface interface-type interface-number
—
Mark the priorities for
packets matching specific
ACL rules
traffic-priority inbound acl-rule { dscp
dscp-value | cos cos-value | local-precedence
pre-value }*
Required
The priority marking function configured on a VLAN is only applicable to packets tagged with 802.1Q
header.
Configuration example
z Ethernet 1/0/1 belongs to VLAN 2 and is connected to the 10.1.1.0/24 network segment.
z Mark the DSCP precedence as 56 for the packets from the 10.1.1.0/24 network segment.
1) Method I: configure priority marking for port Ethernet 1/0/1
<Sysname> system-view
[Sysname] acl number 2000
[Sysname-acl-basic-2000] rule permit source 10.1.1.1 0.0.0.255
[Sysname-acl-basic-2000] quit
[Sysname] interface Ethernet1/0/1
[Sysname-Ethernet1/0/1] traffic-priority inbound ip-group 2000 dscp 56
2) Method II: configure priority marking for VLAN 2
<Sysname> system-view
[Sysname] acl number 2000
[Sysname-acl-basic-2000] rule permit source 10.1.1.1 0.0.0.255
[Sysname-acl-basic-2000] quit
[Sysname] traffic-priority vlan 2 inbound ip-group 2000 dscp 56
Configuring Traffic Policing
Refer to section Traffic Policing for information about traffic policing. Note that, the target-rate argument
is committed information rate (CIR), and the burst-bucket-size argument is committed burst size (CBS).
To Next Page
Loading...