1-9
Operation Command Description
Enable system information
output to the console
info-center console channel
{ channel-number |
channel-name }
Optional
By default, the switch uses
information channel 0 to output
log/debugging/trap information to
the console.
Configure the output rules
of system information
info-center source
{ modu-name | default }
channel { channel-number |
channel-name } [ { log | trap |
debug } { level severity | state
state } ]*
Optional
Refer to
Table 1-8 for the default
output rules of system information.
Set the format of time stamp
in the output information
info-center timestamp { log |
trap | debugging } { boot |
date | none }
Optional
By default, the time stamp format
of the log and trap output
information is date, and that of the
debugging output information is
boot.
To view the debugging information of some modules on the switch, you need to set the type of the
output information to debug when configuring the system information output rules, and use the
debugging command to enable debugging for the corresponding modules.
Table 1-8 Default output rules for different output directions
LOG TRAP DEBUG
Output
direction
Modules
allowed
Enable
d/disab
led
Severit
y
Enabled/
disabled
Severity
Enabled/
disabled
Severity
Console
default (all
modules)
Enable
d
warning
s
Enabled
debuggin
g
Enabled
debuggin
g
Monitor
terminal
default (all
modules)
Enable
d
warning
s
Enabled
debuggin
g
Enabled
debuggin
g
Log host
default (all
modules)
Enable
d
informati
onal
Enabled
debuggin
g
Disabled
debuggin
g
Trap buffer
default (all
modules)
Disable
d
informati
onal
Enabled warnings Disabled
debuggin
g
Log buffer
default (all
modules)
Enable
d
warning
s
Disabled
debuggin
g
Disabled
debuggin
g
SNMP NMS
default (all
modules)
Disable
d
debuggi
ng
Enabled warnings Disabled
debuggin
g
To Next Page
Loading...